BATTERY CARE
To keep batteries in good working condition
follow this maintenance program on a regular basis:
.
1.
The batteries should be kept clean and free
of corrosion. Wash tops and terminals of batteries with a solution of baking soda and water (1 cup (237 mL) baking soda per
gallon (3.8 L) of water). Rinse solution off of the batteries. Do not allow this solution to enter the battery. Be sure terminals
are tight. Let the terminals dry and then coat with Battery Terminal Protector Spray (CCI P/N 1014305).
NOTE: Dispose of waste water properly.
.
2. The electrolyte level in the batteries should be checked weekly. Add water
only after charging, unless
the electrolyte level is below the top of the plates. In this case, add just enough water to cover the plates, charge and then check the level again. Never
charge batteries if plates are exposed above electrolyte
level. For best battery life, add only distilled water.
.
CAUTION
•
Do not overfill the batteries.
NOTE:
A battery watering gun or bottle is available at your dealer
.
3.
The battery hold-downs should
be tight enough so that the batteries do not move while the vehicle is in motion, but not so tight as to crack or buckle
the battery case. Tighten hold-down retaining nuts to 40 in lb (4.5 N·m). The terminal connections should be clean
and tight, and any worn insulation or frayed wires should be replaced. Tighten battery terminals to 110 in-lb (12.4 N·m).
.
See following WARNING:
• If battery wire terminals are damaged or corroded, they should be
replaced or cleaned as necessary.
Failure to do so may cause them to overheat during operation and could result in fire, property damage, or personal
injury.
.
4.
After use, the batteries should be placed on charge. The batteries should never be left discharged any longer than absolutely
necessary (do not leave batteries discharged overnight).
